Chapter 2. CLI Syntax Reference
/cx/ux show initializestatus
This command reports the initializestatus (if any) of the specified unit.
Example:
//localhost> /c0/u5 show initializestatus
/c0/u5 is not initializing, its current state is OK
/cx/ux show name
This feature only applies to 9000 series controllers.
This command reports the name (if any) of the specified unit.
Example:
//localhost> /c0/u5 show name /c0/u5 name = Joe
/cx/ux show serial
This feature only applies to 9000 series controllers.
This command reports the unique serial number of the specified unit.
Example:
//localhost> /c0/u5 show serial
/c0/u5 Serial Number = 12345678901234567890
/cx/ux show qpolicy
This feature only applies to 9550SX, 9590SE, and 9650SE model controllers.
This command reports the queue policy of the firmware. If the queue policy is on, the firmware utilizes the drive queueing policy. If some drives in the unit do not support a queueing policy, this policy will have no effect on those drives.
Note that currently only NCQ will be enabled, not
Example:
//localhost> /c0/u5 show qpolicy /c0/u5 Command Queuing Policy = on
62 | 3ware Serial ATA RAID Controller CLI Guide |
