American Power Conversion PX user manual Installing the Main Intelligence Module MIM

Chapter 5 - System Setup

Installing the Main Intelligence Module (MIM)

The main intelligence module is factory installed. The fol- lowing procedure is provided in the event that the MIM is removed or replaced:

Note: The main intelligence module is installed in the upper right bay of the Power Array frame. The main intelligence mod- ule is always installed in the bottom rack in this bay, and the redundant intelligence module is always installed in the top rack in this bay.

1.Carefully align the installation rail on the MIM with the track that runs along the inside of the bay.

2.Slide the MIM into the bay.

3.Tighten the two retaining screws. Do not overtighten.

4.Swing the flip latch into place, and tighten the screw. Do

not overtighten this screw. See figure 5-9.

Redundant

Intelligence

Module

(RIM)

Main

Intelligence

Module

(MIM)

Fig 5-10 Location of the MIM and RIM

Installing the Redundant Intelligence Module (RIM)

The redundant intelligence module is factory installed. The following procedure is provided in the event that the RIM is removed or replaced:

Note: The redundant intelligence module is installed in the up- per right bay of the Power Array frame. The redundant intelli- gence module is always installed in the top rack in this bay, and the main intelligence module is always installed in the bottom rack in this bay.

1.Carefully align the installation rail on the RIM with the track that runs along the inside of the bay.

2.Slide the RIM into the bay.

3.Tighten the two retaining screws. Do not overtighten.

4.Swing the flip latch into place, and tighten the screw. Do not overtighten this screw. See figure 5-9.

5-4