2If necessary, disconnect the two connectors to completely remove the speaker housing/card guide assembly.
If you need to | Speaker housing/card guide assembly |
completely remove the |
|
speaker housing/card guide |
|
assembly in order to insert the card, then disconnect these two connectors on the main logic board and completely remove the assembly. There is a cluster of three connectors in this area. Disconnect the outer two. They are the connectors for the fan and the speaker.
3Insert the PCI card into the slot. Press the card gently but firmly until the connector is fully inserted.
m Don’t rock the card side to side; instead, press the card straight into the slot. (Rocking the card can damage the PCI slot.)
m Don’t force the card. If you meet a lot of resistance, pull the card out and try again.
m To see if the card is properly connected, pull it gently. If it resists and stays in place, it’s connected. (Make sure you don’t pull the card so much that you accidentally disconnect it.)
108 | Chapter 8 |
