Asante Technologies 6200 manual Free-Standing Desktop Installation

Installation

Free-Standing/

Desktop

Installation

▲Important! Disconnect all cables from the IntraSwitch before continuing.

ΔNote: You can install the IntraSwitch in an equipment rack before installing an expansion module.

1	Place the IntraSwitch on a flat, stable surface.
2	Locate a rack-mounting bracket (supplied) and
	place it over the mounting holes on one side of
	the unit.
3	Insert six screws (supplied) into the holes and
	tighten with a Phillips screwdriver.
4	Repeat the two previous steps for the unit’s
	other side.
5	Place the unit in the equipment rack.
6	Secure the unit by screwing its mounting brack-
	ets to the equipment rack.

▲Important! Make sure the unit is supported until all the mounting screws for each bracket are secured to the equipment rack. Failure to do so could cause the unit to fall, resulting in per- sonal injury or damage to the unit, or both.

If you are installing an MII module at this time, proceed to “Installing MII Modules” on page 2-5.

If you are not installing an MII module at this time, proceed to “Connecting Power” on page 2-6.

The IntraSwitch has four rubber feet on the bottom of the chassis that allow for free-standing installation of the unit.

For free-standing/desktop placement:

Page 2-4