Asante Technologies 6200 manual Installing the IntraSwitch, Installation Guidelines

Installation

Installing the IntraSwitch

Installation Guidelines

Power Requirements

The source electrical outlet should be installed near the IntraSwitch, be easily accessible, and be properly grounded.

Make sure the power source adheres to the following guidelines:

❏Voltage range: 100 to 240 VAC

❏Frequency range: 60/50 Hz

❏Maximum current range: 2 A

Environmental Requirements

The IntraSwitch must be installed in a clean, dry, dust-free area with adequate air circulation to maintain the following environmental limits:

❏Temperature: 0° to 40° C

❏Relative Humidity: 5% to 85% non-condensing

Installation Overview

Avoid direct sunlight, heat sources, or areas with high levels of electromagnetic interference.

Cooling and Airflow

Do not restrict air flow by covering or obstructing air vents on the sides of the chassis.

The table below describes the steps needed to install the IntraSwitch. The steps that are optional are labeled “optional” and the steps that are required are labeled “required.” The sections that follow explain each step in detail.

Page 2-2