Asante Technologies 6200 manual Configuring for Management, BootP Configuration

Installation

PARTITION	1 2 3 4	5 6 7 8	9	10	11 12	MII connection
LINK/RECEIVE		100BASE-TX PORTS	AsantéFAST 100 Hub			must be fibre
Repeater/Hub — UPLINK Port						(2km max length)
						from MII port	from port 16 (Uplink)
						on rear panel

MII 1 MII 2

Power

100Mbps
FDP
Data
Link
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16

straight-through cable

(100m max. length)

			Switched 10/100Mbps Ports
2	4	6	8	10	12	14	16	or
									Console				Port 16 in Uplink mode can
								Normal
								Uplink					be connected to hub using
1	3	5	7	9	11	13	15	Uplink
													straight-through cable
													(100m max. length)
				straight-through cable					1	2	3	4	5 6 7 8	9 10 11 12
				(100m max. length)					PARTITION

LINK/RECEIVE 100BASE-TX PORTS AsantéFAST 100 Hub

cross-over cable

(100m max. length)

straight-through cable

(100m max. length)

PARTITION
	AsantéFAST 100 Hub
LINK/RECEIVE	100BASE-TX PORTS

Repeater/Hub — Standard Port

100Base-TX

Server

Network

Printer Station

Repeater/Hub — STANDARD Port

1	2	3	4	5	6	7	8	9	10	11	12
PARTITION

	100BASE-TX PORTS	AsantéFAST 100 Hub
LINK/RECEIVE

Repeater/Hub — UPLINK Port

straight-through cable

(100m max. length)

Configuring for Management

BootP Configuration

Figure 2-2 IntraSwitch Cabling Scenarios

ΔNote: Pressing the Uplink switch toggles the usage of port 16 from normal to uplink or vice versa.This uplink feature is available only for regular RJ-45 port, and not for MII ports.When port 16 is used for uplink, the connection between port 16 to standard hub is straight- through cable.

To use the IntraSwitch as a managed switch, it must be configured with an IP address.This can be accomplished in one of two ways:

❏automatically using BootP (default)

❏manually via the unit’s Console port

The IntraSwitch is shipped with BootP support. BootP allows the IntraSwitch to be automatically configured with an IP

Page 2-8