Installation

Connecting

Power

Connecting to the Network

10/100 Ports Cabling Procedures

To connect power to the IntraSwitch:

▲Important! Carefully review the power requirements on page 2-2 before connecting power to the IntraSwitch.

1

Plug one end of the supplied power cord into

 

the power connector on the back of the unit.

2

Plug the other end into a grounded AC outlet.

3

The front panel LEDs blink and the Power LED

 

illuminates.

▲ Important! If the power does not come on, refer to Appendix A,“Troubleshooting.”

The unit is ready for connection to the network.

The IntraSwitch unit may be connected to an Ethernet network, with the unit powered either on or off.

1

Connect network devices to the IntraSwitch, fol-

 

lowing the cable guidelines outlined below.

2

After the unit is connected to the network, it

 

can be configured for management capabilities.

See “Configuring for Management” on page 2-8.

The 16 fixed 10/100 ports allow for the connection of 10Base-T or 100Base-TX network devices. The ports are compatible with IEEE 802.3 and 802.3u standards.

▲Important! The IntraSwitch must be located within 100 meters of its attached 10Base-T or 100Base-TX devices.

Page 2-6

Page 30 Page 32
Page 31
Image 31
Asante Technologies 6200 manual Connecting Power, Connecting to the Network, 10/100 Ports Cabling Procedures
Page 30 Page 32
Top Page Image Contents