SIP Release Notes | 1. What's New in Release 6.2 |
1.12.3 Networking Parameters
The table below describes networking parameters from the previous release that have been modified in Release 6.2.
Notes: These parameters are applicable to the Gateway and SBC applications.
| Table | |
|
|
|
Parameter |
| Description |
|
|
|
Firewall Settings |
| Modification: Use_Specific_Interface and AccessList_Interface_ID |
[AccessList] |
| parameters added (all products). |
|
| [AccessList] |
|
| FORMAT AccessList_Index = AccessList_Source_IP, |
|
| AccessList_PrefixLen, AccessList_Start_Port, AccessList_End_Port, |
|
| AccessList_Protocol, AccessList_Use_Specific_Interface, |
|
| AccessList_Interface_ID, AccessList_Packet_Size, AccessList_Byte_Rate, |
|
| AccessList_Byte_Burst, AccessList_Allow_Type; |
|
| [\AccessList] |
|
| Where: |
|
| Use_Specific_Interface = determines whether you want to apply the rule |
|
| to a specific network interface (defined in the Multiple Interface table): |
|
| [0] Disable (default) |
|
| [1] Enable |
|
| AccessList_Interface_ID = network interface (as defined in the Multiple |
|
| Interface table) to which you want to apply the rule. This is applicable if |
|
| you enabled the 'Use Specific Interface' field. |
Version 6.2 | 113 | December 2010 |