
SIP Release Notes | 1. What's New in Release 6.2 |
1.11.3 Media New Parameters
The table below describes the new media parameters for Release 6.2.
Notes: These parameters are applicable only to the Gateway application.
Table
Parameter | Description |
|
|
[T38FaxSessionImmediateStart] | Enables fax transmission of T.38 |
| terminating fax machine. |
| [0] Disable (default) |
| [1] Enable |
| This is used for transmission from fax machines (connected to |
| the device) located inside a Network Address Translation |
| (NAT). Generally, the firewall blocks T.38 (and other) packets |
| received from the WAN, unless the device behind NAT sends at |
| least one IP packet from the LAN to the WAN through the |
| firewall. If the firewall blocks T.38 packets sent from the |
| termination IP fax, the fax fails. |
| To overcome this, the device sends |
| to open a pinhole in the NAT for the answering fax machine. |
| The originating fax does not wait for an answer, but immediately |
| starts sending T.38 packets to the terminating fax machine. |
| Note: To enable |
| NoOpEnable and NoOpInterval parameters. |
T38 Version | Selects the T.38 fax relay version. |
[SIPT38Version] | |
| [0] T.38 version 0 (default) |
| [3] T.38 version 3 = T.38 Version 3 (V.34 over T.38 support) |
Version 6.2 | 95 | December 2010 |