AudioControl VERSION 6.2 Default Gateway per IP Interface, Static Routing Table Enhancements

Models: VERSION 6.2

1 178
Download 178 pages 57.24 Kb
Page 69
Image 69
5.Default Gateway per IP Interface:

SIP Release Notes

1. What's New in Release 6.2

5.Default Gateway per IP Interface:

 

Product

MP-11x

 

MP-124

 

 

 

Mediant 600

 

Mediant 1000

 

 

 

Mediant 800 MSBG

 

Mediant 1000 MSBG

 

 

 

Mediant 2000

 

 

 

 

 

Mediant 3000/TP-6310

 

Mediant 3000 HA/TP-6310

 

 

 

Mediant 3000/TP-8410

 

Mediant 3000 HA/TP-8410

 

 

 

 

Management Protocol

 

 

 

Web

INI

SNMP

EMS

Application

CLI

Gateway/GW

SBC

SAS

This feature provides enhanced routing with its support for multiple default gateways. Each IP network interface (whether it’s Control, Media, or OAMP) can now be defined with a default gateway. This is configured in the existing Multiple Interface table (InterfaceTable parameter).

6.Static Routing Table Enhancements:

 

Product

MP-11x

 

MP-124

 

 

 

Mediant 600

 

Mediant 1000

 

 

 

Mediant 800 MSBG

 

Mediant 1000 MSBG

 

 

 

Mediant 2000

 

 

 

 

 

Mediant 3000/TP-6310

 

Mediant 3000 HA/TP-6310

 

 

 

Mediant 3000/TP-8410

 

Mediant 3000 HA/TP-8410

 

 

 

 

Management Protocol

 

 

 

Web

INI

SNMP

EMS

Application

CLI

Gateway/GW

SBC

SAS

The device’s IP Routing table (StaticRouteTable parameter) has been enhanced to provide offline configuration of IP routing rules. The rules in this table can now be associated with an IP interface defined in the Multiple Interface table (rather than the previously used index). Therefore, the routing decision is now based on the source subnet/VLAN. In the previous release, the routing decision was based on the destination IP address only and therefore, for example, packets from the Media subnet could be routed to the Control subnet and vice versa. This enhanced routing behavior prevents cases where static routes are lost and simplifies the static routes configuration for Control and Media subnets.

In addition, a new table column has been added to provide the current status of a configured route (“Active” or “Inactive”). After adding a new route, the device attempts to apply the route. If the operation fails, the route is marked as “Inactive” until it can become active (following a change in the routing/interface tables).

Version 6.2

69

December 2010

Page 69
Image 69
AudioControl VERSION 6.2 manual Default Gateway per IP Interface, Static Routing Table Enhancements