Wireless Installation and Configuration Guide
Wireless Phone Status Messages
Wireless phone status messages provide information about the wireless phone's communication with the access point and host phone system. The following table summarizes the status messages, in alphabetical order.
Message | Description |
3 chirps | The wireless phone is not able |
| to communicate with the best |
| access point, probably |
| because that access point has |
| no bandwidth available. |
Action
None. This is only a warning, the call will handoff to the best access point once it becomes available.
ASSERTxxx.c | The wireless phone has |
Line yyy | detected a fault from which it |
| cannot recover. |
Record the error code so it can be reported. Turn the wireless phone off then on again. If error persists, try registering a different wireless phone to the phone port. If error still persists, contact Technical Support and repeat the error.
Bad Config | Some needed configuration | Check all required wireless phone |
| parameter has not been set. | configuration parameters for valid |
|
| settings. |
Bad ESSID | The wireless phone is |
| configured for “static ESSID” |
| (as opposed to “Learn once” |
| or “Learn always” and no ESS |
| ID has been entered. |
Enter an ESSID in the configuration settings” or change to one of the "Learn modes.
Charging... | The wireless phone is | No action needed. |
| charging in the desktop |
|
| charger. |
|
Charge Complete | The wireless phone is now |
| fully charged. |
Checking Code | The wireless phone is |
| contacting the TFTP Server to |
| determine if it has a newer |
| version of software that should |
| be downloaded. |
No action needed.
None, this message should only last for approximately one second. If message remains displayed, power off and contact customer support for a replacement phone.
Checking DHCP IP The wireless phone is retrieving DHCP information from the DHCP server.
None. This is information only.
CRC Code Error | The software which has been |
| TFTP downloaded has a bad |
| redundancy code check. |
Try the download again, it is possible the software was corrupted during download. If the error repeats, check that the download image on the TFTP server is not corrupted.
Code Mismatch! | The software loaded into the |
| wireless phone is incorrect for |
| this model phone |
Replace the software image on the TFTP server with software that is correct for the phone model.
Wireless Installation and Configuration Guide | Page 62 |
IP Office |
