Avery ALS 230 manual Dispenser active on, Dispenser stopped OFF, Material initialisation Init

Operators Manual

ALS 230

yError display:

If the display shows e.g. E__XX, the dispenser has recognised an error. A warning is shown by W_XX. As soon as the error has been corrected, you may erase the message by pressing the key ENTER and you will get back to the status the machine was in before the error was indicated.

Note: Data entered in the standard menu are not stored, if the machine is switched off. If you need to store data you have to use the extended menu. Please check if it is of help for you using the product menu in your application.

Display	Menu function	Function data value
ON	Labeller ready
OFF	Label function suspend
POS	label position on product	Up to 999.9 mm
STOD	Label stop position at the	Depends on setting of DIST, Label
	dispensing edge	length and RAMP
VELO	Dispensing speed	0.2 ... 30.0 m/min
STAD	delay time before labelling starts	0,1 ... 999,9 ms
BLOW	apply time	0,1 ... 999,9 ms
INIT	Initialisation of label material	Appears after E__0, E__1 and Power
	(CONT and LPIT are measured	on + FEED key depressed, or if the
	according to label size)	values of CONT and LPIT are
		changed

Dispenser active ___________________________________________________ ON

The dispenser is able to dispense labels.

Dispenser stopped_________________________________________________ OFF

The dispenser function is stopped. Single labels could be dispensed with the FEED key.

Material initialisation _______________________________________________ INIT

A new initialisation of material is necessary. Pressing the FEED key will start the initialisation.

Label position_____________________________________________________POS

The position of the label can be changed by the parameter POS while the machine is in operation. The display is presented in 1/10 mm and means the distance between product sensor and labelling position of the product. The display value 0500 would mean 50.0 mm. By

Release 11/05 Page 27 Operation