Safety Notice
Only qualified personnel should attempt the
Precautions
WARNING: Be sure that you are completely familiar with the safe operation and programming of this equipment. This equipment may be connected to other machines that have rotating parts or parts that are controlled by this equipment. Improper use can cause serious or fatal injury. Only qualified personnel should attempt to program,
WARNING: The stop input to this equipment should not be used as the single means of achieving a safety critical stop. Drive disable, motor disconnect, motor brake and other means should be used as appropriate. Only qualified personnel should attempt to program,
WARNING: Improper operation or programming may cause violent motion of the motor shaft and driven equipment. Be certain that unexpected motor shaft movement will not cause injury to personnel or damage to equipment. Peak torque of several times the rated motor torque can occur during control failure.
WARNING: When operating a motor with no load coupled to its shaft, remove the shaft key to prevent it flying out when the shaft rotates.
CAUTION: The safe integration of this equipment into a machine system is the responsibility of the machine designer. Be sure to comply with the local safety requirements at the place where the machine is to be used. In Europe these are the Machinery Directive, the ElectroMagnetic Compatibility Directive and the Low Voltage Directive. In the United States this is the National Electrical code and local codes.
CAUTION: To prevent equipment damage, be certain that the input power has correctly sized protective devices installed.
CAUTION: To prevent equipment damage, be certain that input and output signals are powered and referenced correctly.
CAUTION: To ensure reliable performance of this equipment be certain that all signals to/from the NextMove BXII are shielded correctly.
CAUTION: Avoid locating this equipment immediately above or beside heat generating equipment, or directly below water or steam pipes.
CAUTION: Avoid locating this equipment in the vicinity of corrosive substances or vapors, metal particles and dust.
| MN1904 |