Connections
3 CONNECTIONS
AC Power (mains) Cord Connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector at the backside of the projector.
See installation instructions before connecting to the supply. | Th is d evice co mp li es w it h part 15 of | |
th e FCC ru les. | Op erati on i s su bj ect to | |
Voir la notice d'installation avant de raccorder au réseau. | fo llo win g two co ndi tio ns (1). Th is | |
| d evice may n ot cau se harmf ul i nt er - | |
| f eren ce, an d ( 2) t hi s d evice mu st | |
| accep t any in terf erence received | |
| i nclu di ng i nt erferen ce t hat may cause | |
120/230 V | un desi red op erat io n" | |
|
| |
7/5 Amp | 75 Ohm | 75 Ohm |
50/60 Hz |
|
|
PORT 4/5 | PORT 2 |
|
7/5 Amp |
50/60 Hz |
Power Check
Power voltage indication on sticker on the back side of the projector. The power voltage is indicated by the art. no.
Warning !
Check if the indicated power voltage corresponds to that of the wall outlet.
Art. No. R9000901 must be connected to a 230 VAC power source. Art. No. R9000908 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for power adaptation of the projector.
RS232 IN | RS232 OUT IR | REMOTE |
IN RS232 | OUT RS232 IR | REMOTE |
Switching On/Off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis- played) or in the 'stand by mode', depending on the position of the 'power up' dip switch on the controller unit. This DIP switch must be set during installation by a qualified technician. If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector switched off
green color : projector in Operational mode
red color : projector is in Standby mode.
|
|
| This device complies with part 15 of |
|
|
| the FCC rules. Operation is subject to |
|
|
| following two conditions (1). This |
|
|
| device may not cause harmful inter- |
|
|
| ference, and (2) this device must |
|
|
| accept any interference received |
VIDEO | OFF - ON | green : operation | including interference that may cause |
undesired operation" | |||
| 75 Ohm | red : standby |
|
PORT 1 | PROJECTOR MODE |
5975007 BARCOGRAPHICS 808S 051196 |
| |
|
