Controlling
4 CONTROLLING
Caution : Do not display a stationary image with full brightness and contrast for longer than 20 min., otherwise you risk damage to the CRT's.
Battery installation in the RCU.
A new battery (not yet installed to save the battery life) is delivered inside the plastic bag with the power cord. Before using the RCU, follow the battery installation procedure.
Remove the battery cover on the backside of the RCU by pushing the indicated handle a little to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type 6F22S or equivalent) in the lower compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Contact plate
Battery
Insert here, behind the plastic cover, the 'Insert card for RCU'. You can cut out the correct insert card on one of the last pages of this manual.
fig.2
310a.DRW
5975007 BARCOGRAPHICS 808sS 160996 |
| |
|
