Controlling
The BARCOGRAPHICS 808s can be controlled with a. the RCU
b. the hardwired RCU (cable not included) c. the
The procedure and results of controlling the projector with either of these RCU options is essentially the same.
How to use your RCU
c) RCU used in a hardwired configuration.
RS232 IN RS232 OUT IR | REMOTE |
IN RS232 OUT RS232 IR ER | |
a) Point the front of the RCU towards the reflective screen surface
Ceiling
IR sensor
219
Screen
RCU
b)Point the front of the RCU towards one of the IR sensors in the projector.
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote control unit and the projector's IR sensor.
IR Receiver Locations on the Projector:
Front of projector | Rear side of projector |
RS232 IN RS232 OUT I R REMOTE
IN RS232 | OUT RS232 | IR | "ThisdevicecoOpemplieswiratioissubjecnthPart toof |
|
| REMOTE | devicefollowingtwomaynotccauseonditions:(harm1)fulinteThisr- |
|
|
| accferenceept,anyand(inte2) rfethreisncdeviceerecmusteived, |
|
|
| undesiredincludinginteoperation"rferencethatmaycause |
9 | 0 | RCU | 9 | 0 |
7 | 8 |
| 7 | 8 |
5 | 6 |
| 5 | 6 |
|
|
|
| |
3 | 4 |
| 3 | 4 |
1 | 2 |
| 1 | 2 |
Plug one end of the remote cable in the connector on the bottom of the RCU and the second side in the connector in the rear panel of the BARCOGRAPHICS 808s labelled 'REMOTE'.
d)
To gain access to the
Projector Address
a. hardware set up of the projector address.
Every projector requires an individual address between 0 and 255 which is set with hardware DIP switches inside the projector. To change that address, contact a BARCO authorized technician.
b. How to control the projector.
The projector's address may be set to any value between 0 and 255. When the address is set, the projector can be controlled now with :
-the RCU for addresses between 1 and 9.
-computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Note : a projector will respond to a RCU set to an address of '0' regardless of what address is set in the projector itself. Address "O" is therefore a universal address.
c. Using your RCU.
Before using your RCU, it is necessary to enter the projector address into the RCU (only when that address is between 1 and 9). The projector with the corresponding address will listen to that specific RCU.
When address 0, 'zero address' is programmed into the RCU, every projector, without exception will listen to the commands given by this RCU.
| 5975007 BARCOGRAPHICS 808sS 160996 | |
|
