Barco R9000901, R9000908 Connecting a RGB Analog source to port 4/5, Analog Input Selection

Connections

Connecting a RGB Analog source to port 3.

Connect your RGB source via an interface to Port 3.

Always use an interface when a computer and local monitor have to be connected to the projector.

Barco interfaces which can be applied :

Universal analog interface		R9826100
RGB 120 MHz analog interfaceR9826570
VGA interface	120V	R9828079
	230V	R9828070
MAC interface	120V	R9828059
	230V	R9828050
MAGIK interface	120V	R9828129 & R9828128
	230V	R9828120 & R9828121

See installation instructions b efore connecting to the supply.

Voir la notice d'in stallation ava nt de r accorder au rés eau.

12 0/2 30 V
7/5 Amp	75 Ohm	7 5 Ohm
50/60 Hz
PORT 4/5	PORT 2

This device complies with part 15 of the FCC rules. Operation is subject to following two conditions (1). This device may not cause harmful inter- ference, and (2) this device must accept any interference received including interferencethat maycause undesired operation"

RGB analog input with automatic sync detection. (Separate H and V sync inputs, with composite sync input or with sync signals on green)

Pin configuration D9 connector of the Analog input.

1not connected

2ground RGBS

3RED

4GREEN

5BLUE

6ground RGBS

7ground RGBS

8Hor/comp. sync

9Vert. sync

Analog Input Selection :

with the RCU or build in RCU, press digit button 3.

ON	ANALOG INTERF. 120MHz INPUT
		B	H	V
OFF		G
	R		INP	INP
			75 o h m t erm .	in ver.

361

Connecting a RGB Analog source to port 4/5.

RGB analog input terminals with separate H and V sync inputs, with composite sync input or with sync signals on green (automatic sync detection).

Always use an interface when a computer and local monitor have to be connected to the projector. See 'Connecting a RGB Analog source to port 3' for a list of BARCO interfaces which can be applied.

See installa tion ins tructions befor e conne cting to the supply.

Voir la notice d'installation avant de raccorder au réseau.

12 0/2 30 V
7/5 Amp	7 5 Ohm	7 5 Ohm

50/60 Hz
PORT 4/5	POR T 2

This device complies with part 15 of the FCC rules. Operation is subject to following two conditions (1). This device may not cause harmful inter- ference, and (2) this device must accept any interf erence received including interference that may cause undesired operation"

RGB input selection :

(RGB : R, G, B signals with automatic sync detection)

with the RCU or the build in RCU : press digit button 4 or 5

ON	ANALOG INTERF. 120MHz INPUT		H	V
		B
OFF		G
	R		INP	INP

75 ohm term. inver.

363

3-4 5975007 BARCOGRAPHICS 808S 051196