Messages, warnings and failure codes
8 MESSAGES, WARNINGS AND FAILURE CODES
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
enter
password
xxxx
text on
text off
PROJECTOR
ADDRESS :
003
WARNING :
input not available
When selecting a new source, information about this source will be displayed on the screen. Source number, horizontal and vertical frequencies of the dis- played source.
Announcement of the selected source.
Message to enter your password. Password contains 4 digits.
These messages will be dis- played on the screen when push- ing the <TEXT> key.
Text ON : the 'bar scale indica- tion' will be enabled during the change of an analog control in the 'operational mode' + all warn- ings and failures will be displayed.
Text OFF : the 'bar scale indica- tion' will be disabled during the change of an analog control in the 'operational mode' + all warn- ings and failures will not be dis- played.
Indication of the projector ad- dress when activating the 'AD- DRESS' button on the RCU with a pencil or other small object.
When using the projector with the RCVDS, this warning will be displayed when selecting an in- put slot of an RCVDS where the input board is missing.
WARNING :
source not
available
WARNING :
invalid
key entry
WARNING :
invalid
code entry
WARNING :
end of ad- just range
WARNING :
input no
longer
available
check input signal
or select
new source
WARNING :
input selector
not
available
The input is a valid input but the source is not connected to the input terminals or the input source is switched off.
When a wrong key is pressed on the RCU.
Message when the entered pass- word is wrong.
End of adjustment range.
Message will be displayed when the input source is no longer available. The following message then appears: 'check input sig- nal or select new source'.
This message will be displayed after the message 'input no longer available'. It asks to check the connections between the source and the projector or to check if the source is switched on.
It warns you to check the power connection or the power status of the RCVDS.
Next message will appear imme- diately on the screen : 'go to
5975007 BARCOGRAPHICS 808s 160996 |
| |
|
