Barco R9001330 owner manual Change Projector Address, Change Baudrate PC

Service Mode

Change Projector Address

Every projector requires an individual address between 0 and 255. This address can be software installed.

To change that address, push the control disk up or down to highlight Change Proj. Address and press ENTER. The Change Projector Address menu will be displayed and the actual address will be filled in. The first digit is highlighted. Enter the new projector address with:

-the digit keys on the RCU or the local keypath or

-use the control disk to the right or to the left to select a digit and change the value by pushing the control disk up or down until the new value is reached. Continue with the other digits on the same way.

SERVICE

IDENTIFICATION

CHANGEPASSWORD

CHANGE LANGUAGE

CHANGE PROJ. ADDRESS CHANGE BAUDRATE PC RESET LAMP RUNTIME LAMP RUNTINE HISTORY

PANEL ADJUSTMENTS

I2C DIAGNOSIS

CHANGE PROJ. ADDRESS

Enter new address

001

Select with	or
Reprogram with	or

or numeric keys

<ENTER> to confirm

<EXIT> to return

Change Baudrate PC

The communication speed between projector and computer, e.g. PC or MAC, has 8 possible speeds. The baud rate speed can be software set up.

Highlight Change Baud rate PC by pushing the control disk up or down and press ENTER to display the Change Baudrate PC.

SERVICE

IDENTIFICATION

CHANGEPASSWORD

CHANGE LANGUAGE

CHANGE PROJ. ADDRESS

CHANGE BAUDRATE PC

RESET LAMP RUNTIME

LAMP RUNTINE HISTORY

PANEL ADJUSTMENTS

I2C DIAGNOSIS

Select with or then <ENTER> <EXIT> to return.

13-10 5975288 BARCOGRAPHICS 8200 110497