Barco R9001330 owner manual Switching to stand-by, Switching off, Power Connection

Power Connection

When the total run time of the lamp is 970 hours or more, the following message will be displayed for 1 minute. This message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.

When the total run time of the lamp is 1000 hours or more, the following message, with the exact run time is displayed on the screen.

Lamp run time is 1000 hours. Operating the lamp longer than 1000 hours may damage the projector. Please replace the lamp.

When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.

The total lifetime of the lamp for a safe operation is 1000 hours max. (normal power mode). Do not use it longer. Replace always with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.

Warning : Using a lamp for more than 1000 hours is dangerous, the lamp could explode.

Switching to stand-by. Switching off

Lamp run time

980 h

WARNING

Lamp run time is 1000 hours Operating the lamp longer than 1000 hours may damage

the projector.

Please replace the lamp

<ENTER> to continue

When the projector is running and you want to go to stand-by, press the stand-by key.

Caution : Before powering down the projector, switch the projector to stand-by and let the projector lamp cool down until the fans stop blowing (or for at least 15 minutes).

To switch off:

-press first STANDBY key and let cool down until the fans stop blowing ( or at least 15 min).

-switch off the projector with the power switch.

6-4 5975288 BARCOGRAPHICS 8200 110497