
Start Up of the Adjustment Mode
Adjustment Mode
All source set ups, picture tunings and geometry are made while in the 'Adjustment mode' . Press the ADJUST or ENTER key to enter the 'Adjustment mode'.
You are now in the 'Adjustment mode'. The control stick (RCU) or '+ or
There are 4 possible paths to follow once in the Adjustment mode. They are :
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with or
then <ENTER>
<EXIT> to return.
Installation - Installation should be selected if a new input module is installed or a new source is connected to an existing input module. Also when the projector is relocated in a new configuration.
Guided - Guided should be selected if the user intends to perform a complete new set up. All of the necessary adjustments or set ups are made in a predetermined sequence.
Random Access - Random Access should be selected if the user is used to set up a source.
Service - Service should be selected if the user intends to change general settings such as password, language, address, etc.or some service actions as reset lamp run time, panel adjustments, etc. or get
| 5975288 BARCOGRAPHICS 8200 110497 | |
| ||
|
|
|