Barco R9001330 Terminology, Control disk on RCU or + and - keyscursor keys to, key down

Location and Functions of Control

Terminology

Back light key : when activated, all keys will be lighted up

1and visible in the dark.

ADJ. : ADJUST key, to enter the adjustment mode or for

2quick exit in the adjustment mode.

Address key (sunk key), to enter the address of the projec-

3tor (between 0 and 9). Press the sunk address key with a pencil, followed by pressing one digit button between 0 and 9.

STBY : stand by button - to start projection when the

4power switch is switched on.

-to switch off the projector

without switching off the power switch.

PAUSE : to stop projection for a short time, press 'PAUSE'.

5The image disappears but full power is retained for imme- diate restarting.

TEXT : when adjusting one of the image, e.g. controls

10during a meeting, the displayed bar scale can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key only active in operational mode.

11FREEZ : press to freeze the projected image.

ENTER : to start up the adjustment mode or to confirm an

12adjustment or selection in the adjustment mode.

EXIT : to leave the adjustment mode or to scroll upwards

13when in the adjustment mode.

Control disk (on RCU) or '+' and '-' keys(cursor keys): to

14make menu selections when in the adjustment mode. The control disk can move up, down, to the right or to the left.

Comparision between control disk movement and the use of the cursor keys on the local keypad :

RCU	=	local keypad
control disk up	=	'+' key up

6

7

HELP : on line help information.

Digit buttons : direct input selection.

Picture controls : use these buttons to obtain the desired

control disk down	=	'-' key down
control disk to the right	=	'+' key right
control disk to the left	=	'-' key left

Use the '+' and '-' keys (cursor keys) : to increase or decrease the analog level of the image controls when they are first selected.

8 picture analog level (see also 'Controlling').

RC operating indication : lights up when a button on the

9

PHASE : used to remove the instability of the image.

15remote control is pressed. (This is a visual indicator to check the operation of the remote control)

5975288 BARCOGRAPHICS 8200 110497 5-5