Installation
If both lines are correctly converged, continue with screw 4.
Adjust screw 4 until line 4 is correctly converged. It is possible that line 2 and 3 have to be reconverged. If so, repeat procedure for screw 2 and 3 (step b and c)
If line 2, 3 and 4 are converged, continue with line 1 (screw 1).
When line 1 is converged, check again the convergence of lines 2, 3 and 4. If necessary repeat the above procedure for the corresponding lines.
Check if lines 5 and 6 are correctly converged. If so, press EXIT to return to the Test pattern menu and continue with Blue on green.
If not yet correctly converged, check the distance between lines 5 and 6 of the red pattern and the distance between lines 5 and 6 of the green lines.
Two possibilities :
1) distance between red lines is smaller than distance between green lines.
Turn screw 5 and 6 clockwise until distance between lines 5 and 6 is the same for the red and green lines.
2) distance between red lines is greater than distance between green lines.
Turn screw 5 and 6 counter clockwise until distance between lines 5 and 6 is the same for the red and green lines.
Due to this movement the lines 1, 2, 3 and 4 may be out of convergence. Repeat the above mentioned steps for the respective lines.
If all lines are correctly converged, press EXIT to return to the Test pattern menu.
5975288 BARCOGRAPHICS 8200 110497
| 4 |
| 1 |
6 | 5 |
3 | 2 |
| 4 |
| 1 |
6 | 5 |
3 | 2 |
|
|
