Connections
Input connections.
The projector has modular input facilities. The input slots can be filled up with the following modules :
Video,
RGBS/RGsB analog input order no. : R9827910
RGB3S/RG3sB input
order no. : R9827920 Component Video input
order no. : R9827930
The sequence of insertion has no importance, exept when using a RCVDS or VS05. It is even perfectly possible to insert several input modules of one type.
Note : When using a RCVDS05 or VS05, the input configuration of the projector must be as follows:
Slot 1 : video input module
Slot 2 : RGB analog input module
Slot 3 : Component input module
Input module insertion into the projector :
| DIAGNOSTICS |
|
IR- ACKNO WLEDGED | CODE | IR- RECEI VER |
R S 2 32 O U T |
|
|
IR- RECEI VED |
|
|
0 I
-Power down the projector and disconnect the power cord from the wall outlet.
-Remove the dummy plate covering the chosen input slot by turning out both screws.
-Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
-Press on both handles of the input module until the module plug seats in the connector of the projector.
-Secure the input module by tightening both retaining screws.
-Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
| 5975288 BARCOGRAPHICS 8200 110497 | |
| ||
|
|
|
