
1
2
3
4
Port
RESET
LAN
1X — 8X
WAN
DC12V
Meaning
After the device is powered on, press it to reset the device or restore to factory default settings.
6 seconds above: restore to factory default settings (this is used when you cannot login to the router. E.g. forgot the password)
Connect a UTP Ethernet cable
WAN 10/100M Ethernet port (with auto crossover support); connect xDSL/Cable modem here.
Connect DC power adapter here.(DC12V Power)
1.3.2.3Cabling
Most Ethernet networks currently use unshielded twisted pair (UTP) cabling. The UTP cable contains eight conductors, arranged in four twisted pairs, and terminated with an RJ45 type connector.
One of the most common causes of networking problems is bad cabling. Make sure that all connected devices are turned on. On the front panel of BiGuard 2, verify that the LAN link and WAN line LEDs are lit. If they are not, check to see that you are using the proper cabling.
15