14
®
The ServSwitch CX unit is supplied
with a single 30W power adapter
which is sufficient to supply any
configuration of the unit. All
ServSwitch CX units have two
power input sockets to allow
auxiliary (redundant) power
adapters to be connected. There
are no on/off switches, so operation
begins as soon as a power adapter
is connected.
Note: ServSwitch CX units require a heavy duty power adapter at either or
both power input connectors. Use only the adapter supplied with the unit or
available separately from Black Box. Do not use the standard 10W adapters that
are supplied with other Black Box products, such as the ServSwitch CX Remote
module.
To connect the power supply
1 Attach the output lead from the power adapter to the MAIN PWR IN socket
on the rear panel of the ServSwitch CX.
2 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power adapter.
3 Connect the power lead to a nearby main supply socket.
4 Repeat steps 1 to 3 for the auxiliary power adapter (using the AUX PWR IN
socket), if a backup supply is required.
Note: Both the ServSwitch CX and its power supply generate heat when in
operation and will become warm to the touch. Do not enclose them or place
them locations where air cannot circulate to cool the equipment. Do not operate
the equipment in ambient temperatures exceeding 40 degrees Centigrade. Do
not place the products in contact with equipment whose surface temperature
exceeds 40 degrees Centigrade. Using two power supplies will ensure that each
power supply takes less load and run at a correspondingly cooler temperature.
OPTIONS
13
24
5V5V
WARNING
!
RJ45CONNECTORSONTHIS
PANELAREFORCONNECTION
TOKVMEQUIPMENTONLY.
DONOTCONNECTTO NETWORK OR
TELEPHONESYSTEMS
5A5A
AUXPWRINMAINPWRIN
CATxUSERPORT
Madein
theU.K.
Indooruse only
123
ON
ServSwitch CX rear
panel
output lead from
power adapter
POWER
SWITCH
SERVER
SYSTEM
SAM
LOCAL
USER REMOTE
USER
CX R
MODEM
/ISDN
POWER
IN
GLOBAL
USER
IP
®
724-746-5500
®