To select a server using hotkeys
1 Simultaneously press and hold 
and 
.
Note: The 
and 
keys when pressed in combination are called ‘hotkeys’ and they signal to the ServSwitch CX that you wish to control it, rather than the server. However, if these particular hotkeys clash with another device or program, then your administrator may change them to a
different combination. If the 
combination fails to work, then please contact the system administrator for details.
2While still holding 
and 
, press the first numeral of the required port address, then:
•If the port address is a single character, release all of the keys.
•If the port address is two or more characters, release the first numeral key and press the second – repeat this procedure until all of the port
address numerals have been entered, then release 
and 
.
Note: The numbers on your keyboard’s numeric keypad are not valid, use only the numeral keys above the QWERTY section.
Note: If your user port does not have authorisation to view the selected port then an ‘Insufficient user rights’ messages will be displayed.
Standard hotkeys
The range of hotkey combinations are as follows:
Note: If your hotkeys have been changed, substitute them for 
and 
in the examples given here.
| Selects port 1 |
| |
| Selects port 2 |
| |
• | • |
|
|
• | • |
|
|
then | Selects port 10 |
| |
• | • |
|
|
then | Selects port 24 |
| |
| Note: When entering multiple digit addresses | ||
| as above or for even longer cascaded servers, | ||
| keep | and | pressed down until all other |
| numbers have been entered. | ||
Selects the next available port
Selects autoscan mode where each (authorised) port is displayed for a period determined by the administrator. To cancel autoscan mode, simply select any fixed channel using any of the suggested methods.
Switches off the video signal – this will cause a power saving monitor to enter its standby mode. To awaken the monitor, simply select any fixed channel using any of the suggested methods.
Logs out the current user (if security is enabled) or selects port 0 to disable the video signal (if security is disabled).
& , , or | Moves the currently displayed |
| around the screen. |
®
50
