Bosch Appliances LTC 8600, LTC 8800 instruction manual User Function 45 CPU Temperature Status

82 en LTC 8600 LTC 8800 Series

Some minor disturbance of the video images may be visible for 1 or 2 seconds while the cameras are being adjusted. If no changes are noticed, check to make sure that you have compatible devices in your system.

If using an LTC 8555 keyboard, press [User] to exit the mode.

User Function 45 – CPU Temperature Status

Use this function to view the condition of the CPU temperature. Once the function is entered, the condition is displayed on the monitor text display.

If using the LTC 8555 keyboard, press [User] to exit the mode.

User Function 46 – Two/Three Line Titles

Use this function to enable a third line of on-screen text. This new line can be used to display up to 24 additional camera title characters, providing a total of 40 charac- ters (or 20 'double width' characters) for each camera. Alternatively, this line can be used to display the 12-character Monitor title.

Once the function is entered, move the joystick up/down to select the desired option. Enter a valid user password, and press [Enter]. The on-screen display of some system monitors may take up to 1 minute before changing.

After enabling/disabling this feature, it is recommended to enter User Function 24 (see above) to adjust vertical height of the on-screen text to the desired position.

Note: At time of this publication, the available version of the PC-based LTC 8059 Master Control Software only supports user programming of the standard 16 char- acters of the camera titles. The additional 24 characters can only be programmed using User Function 9 (see above) or via third party RS-232 serial interface utilizing the Allegiant Command Console Language (CCL) commands.

User Function 47 – Six-digit Camera ID

Use this function to enable/disable “6-digit Camera ID” mode. When enabled, 2- digit “site numbers” are displayed in addition to the 4-digit camera number. The 2- digit site number feature is especially useful when groups of cameras are located in separate buildings, floors, or other common areas.

By default, all 6-digit camera numbers are assigned to site “00” and the remaining digits correspond to the standard 4-digit camera numbers. Use the PC-based LTC 8059 Master Control Software to enter unique 6-digit camera numbers for each sys- tem camera. When enabled, all keyboard based camera selections and Sequence programming must be done using the 6-digit number.

Once the function is entered, move the joystick up/down to select the desired option. Enter a valid user password, and press [Enter]. The on-screen display of some system monitors may take up to 1 minute before changing.

Note: This feature requires firmware versions released for certain system compo- nents in March 2009. If necessary, compare firmware versions against the list of components below to determine if the feature is available in your system:

COMPONENT	Firmware Version
LTC 8x10/01 series CPU/Data Receiver modules	10.05 or later
Intuikey keyboard firmware	1.93 or later
LTC 8555 keyboard firmware	5.90 or later
LTC 8834/00 Video Output Module	3.30
LTC 8059/00 Master Control Software	2.90

User Function 99 – User Function Index

This function is an index listing of all Keyboard User Functions. Move the joystick up or down to view an abbreviated description of the function number currently shown in the first line of the monitor display. Only those functions available to the user (based on their priority level) will be displayed.

Bosch Security Systems, Inc. Instruction Manual F.01U.127.393 2.0 2009.03