LTC 8600 LTC 8800 Series | en 83 |
|
|
19 Maintenance Information
The Allegiant system has been designed to perform for long periods of time with lit- tle or no maintenance. Occasionally the need will arise to clean the keyboard, or replace a fuse. Follow the instructions below if any of these items are required.
19.1 Cleaning the Keyboard
The keyboard may be cleaned whenever deemed necessary simply by temporarily removing it from the system and wiping it with a damp cloth. If a conventional spray type cleaner is required, spray the cloth first, then wipe off the surfaces. Do not use petroleum based cleaners or cleaners containing benzene, triclorethylene, ammonia or acetone, as these cleaners could damage the plastic surfaces.
19.2 AC Line Voltage Input Selection
The AC line voltage input selector is found on the rear of the equipment bay inside the line cord connector housing. The present input voltage selection will be shown in the window of the connector housing. Remove AC line cord if the setting is incor- rect. To change the setting, insert a flat blade screwdriver into the slot located at one end of the connector housing as indicated in the drawing and rotate the screw- driver until the door to the housing opens.
Figure 19: AC line voltage input connector
Remove the voltage selector wheel from the connector housing and rotate until the desired voltage is visible.
Linene VoltageVoltage
Selectorlector
Removal
Removal
Figure 20: Line voltage selector
Reinsert the wheel back into the connector housing so that the selected voltage is facing out. Snap door closed and verify that the correct voltage selection is visible through the window. Reattach AC line cord.
F.01U.127.393 2.0 2009.03 | Instruction Manual | Bosch Security Systems, Inc. |
