Bosch Appliances LTC 8600 8.5Camera and Monitor Video Connections, Bay Type, Module, DIP Setting

30 en LTC 8600 LTC 8800 Series

Figure 7: Typical CPU Module Insertion

If an LTC 8802 Series Monitor Expansion is supplied, it will contain an

LTC 8816/01 Data Receiving Module in this slot. Install the main bay CPU or data receiver module at this time.

The circuit board contains three (3) 8-position DIP switches for system configura- tion options. The DIP switches can be used to modify certain system operating con- ditions. Review the Factory Default Settings Section to determine if it is necessary to change the DIP switches from the factory default positions. For reference, the factory default settings are:

Bay Type	Module	DIP Setting
LTC 8601 Series	LTC 8610/01 CPU	S1 and S3, All OFF
		S2, Switch 5, 7, and 8 ON; All others OFF
LTC 8801 Series	LTC 8810/01 CPU	S1 and S3, All OFF
		S2, Switch 5, 7, and 8 ON; All others OFF
LTC 8802 Series	LTC 8816/01	S1 and S3, All OFF
		S2, Switch 3 and 7 ON; All others OFF

8.5Camera and Monitor Video Connections

Refer to “Figure 14:” on page 43 for the next series of steps.

Connect the system cameras to the appropriate video inputs, but as a minimum connect one known operating camera to video input #1 on the rear of the main CPU bay. Use only those inputs that correspond to an installed VIM. Special instructions concerning the LTC 8600 Series or the LTC 8800 Series systems, termination, and expansion bays are given in the sections below. Also connect desired monitors to the rear of the main CPU bay, ensuring to connect at least one monitor to video out- put #1. The video outputs are the left-most column of BNC connectors on the rear of the bay. Use only those outputs that correspond to an installed Video Output Module (VOM).

8.5.1LTC 8600 Series and LTC 8800 Series Video Input Connections

The LTC 8601 Series and the LTC 8801 Series main bays have 96 direct BNC connectors available for video input. Cameras above 96 require the use of the LTC 8808/00 Video Interconnect (“Patch”) Panel. Each patch panel provides 32 additional BNC connectors for video input.

Patch panels are connected to the rear of the main bay using the supplied ribbon cables. Each cable can carry video for up to 16 cameras. Two (2) cables can be attached to each patch panel to support up to 32 cameras per panel. Each ribbon cable should be attached to the appropriate “VIDEO” connector on the rear of the main bay. The ribbon cable connectors contain a small “key” protrusion formed into one side of the connector to assure proper placement into the mating connectors. Be careful not to force the cables into the mating connectors backwards. For exam- ple, the two (2) ribbon cables from the first patch panel (supporting the 32 cam-

Bosch Security Systems, Inc. Instruction Manual F.01U.127.393 2.0 2009.03