Bosch Appliances LTC 8800, LTC 8600 User Function 31 Set Printer RS-232 Parameters

LTC 8600 LTC 8800 Series en 79

User Function 31 - Set Printer RS-232 Parameters

This function is used to set the RS-232 baud rate and handshake options for the sys- tem's printer port. Upon entry to the mode, the current settings are displayed. Move the joystick up/down to select the baud rate, and left/right to select the handshake option. After being changed, the port is also automatically set to eight data bits, no

parity, and one stop bit. Once new settings have been selected, enter the user pass- word and press [Enter]. If using the LTC 8555 Series keyboard, press [User] to exit.

User Function 32 - Set Alarm RS-232 Parameters

Use this function to select the RS-232 baud rate and handshake options for the sys- tem's alarm port. Upon first entering the mode, the current settings will be dis- played. Moving the joystick up/down selects the baud rate. Moving the joystick left/ right selects the handshake option. After being changed, the port is also automati-

cally set to eight (8) data bits, no parity, and one stop bit. Once the new settings have been selected, enter the user password and press [Enter]. Press [User] to exit

the mode.

User Function - Display User Number and Priority

This function displays the current user's number and priority level on the monitor screen. The user number will be displayed on the top line and the user's priority

level will be displayed on the bottom line of the monitor screen. If using the LTC 8555 Series keyboard, press [User] to exit.

User Function 34 - Camera Indicator

This function is used to enable an onscreen indicator to identify a pan/tilt equipped camera. Move the joystick up or down to select DISP CAM CONTROL or NO CAM CONTL DISPL. Press [Enter] to activate your selection. When enabled, cameras iden-

tified as controllable (via User Function 35 or the optional LTC 8059/00 MCS pack-

age), show a in the middle of the first line of monitor text.

User Function 35 - Controllable Cameras

Priority 1 users can use this function to select camera sites equipped with pan/tilt

devices. Move the joystick up or down to select the camera number, and left or right to select FIXED or MOVABLE. User Function 34 or the optional PC software package

enables or disables the display of the controllable camera indicators on the system monitor displays.

User Function 36 - Select Crosspoint Data

Use this function to select options for accessory device data that can be sent out the biphase control port. Move the joystick up or down to select XPOINT DATA, ALARM XPOINT, or PHYSICAL CAMERA NUMBER, and left or right to enable/disable

the selected option. These options are typically applicable only when LTC 8770 Series Switcher Follower accessory devices are being used in the system.

User Function 37 - R/D Address Mode

Priority 1 users can use this function to select whether the biphase control data

commands will be addressed using the cameras' logical numbers or physical num- ber indexes in the Camera Table. Move the joystick up or down to select LOGICAL or PHYSICAL and press [Enter] to activate your selection. If this option is set to LOGI-

CAL, AutoDome Series cameras and Allegiant Series receiver/drivers should be addressed using the cameras' logical identification number. If it is set to PHYSICAL,

the devices should be addressed using the cameras' physical port number.

F.01U.127.393 2.0 2009.03 Instruction Manual Bosch Security Systems, Inc.