
104 en Operation | VideoJet X40 SN |
|
|
Connecting with a Terminal Program
Various requirements must be met in order to operate with a terminal program (see
Section 8.9 Communication with Terminal Program, page 116).
1.Start the terminal program and enter the command 1 in the main menu to switch to the IP menu.
2.Enter the command 4 in the IP menu to change the remote IP address, then enter the IP address of the unit you wish to connect to.
3.Enter the command 0 to return to the main menu and then enter the command 4 to switch to the Rcp+ menu.
4.In the Rcp+ menu, enter the command 5 to activate the automatic connection.
Closing the Connection with a Terminal Program
1.Start the terminal program and enter the command 4 in the main menu to switch to the Rcp+ menu.
2.In the Rcp+ menu, enter the command 5 to deactivate the automatic connection.
DOC V4.0 2009.06 | Installation and Operating Manual | Bosch Security Systems |