Bosch Appliances X40 SN Advanced Mode Alarm Connections, Connect on alarm, Destination IP address

VideoJet X40 SNConfiguration Using a Web Browser en 63

5.27 Advanced Mode: Alarm Connections

You can select how the VideoJet X40 SN responds to an alarm. In the event of an alarm, the unit can automatically connect to a pre-defined IP address. You can enter up to ten IP addresses to which the VideoJet X40 SN will connect in sequence in the event of an alarm, until a connection is made.

Connect on alarm

Select On so that the VideoJet X40 SN automatically connects to a predefined IP address in the event of an alarm.

By setting Follows input 1 the unit maintains the connection that has been automatically established for as long as an alarm exists on alarm input 1.

NOTICE!

i In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind when assigning the profile (see Section 5.19 Advanced Mode: Encoder Profile, page 48).

Number of destination IP address

Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit contacts the remote stations one after the other in the numbered sequence until a connection is made.

Destination IP address

For each number, enter the corresponding IP address for the desired remote station.

Bosch Security Systems Installation and Operating Manual DOC V4.0 2009.06