86 en Configuration Using a Web BrowserVideoJet X40 SN

5.40

Advanced Mode: Multicasting

In addition to a 1:1 connection between an encoder and a single receiver (unicast), the VideoJet X40 SN can enable multiple receivers to receive the video signal from an encoder simultaneously. The device either duplicates the data stream itself and then distributes it to multiple receivers (Multi-unicast) or it sends a single data stream to the network, where the data stream is simultaneously distributed to multiple receivers in a defined group (Multicast). For each encoder (video input) you can enter a dedicated multicast address and port for each stream. You can switch between the streams by clicking the appropriate tabs.

NOTICE!

i

Multicast operation requires a multicast-enabled network that uses the UDP and the Internet

 

 

Group Management IGMP protocols. Other group management protocols are not supported.

 

The TCP protocol does not support multicast connections.

 

 

A special IP address (class D address) must be configured for multicast operation in a multicast-enabled network.

The network must support group IP addresses and the Internet Group Management Protocol (IGMP V2). The address range is from 225.0.0.0 to 239.255.255.255.

The multicast address can be the same for multiple streams. However, it will be necessary to use a different port in each case so that multiple data streams are not sent simultaneously using the same port and multicast address.

NOTICE!

i You must set the parameters for each encoder (video input) and for each stream individually. The numbering follows the labeling of the video inputs on the actual unit.

Enable

To enable simultaneous data reception on several receivers you need to activate the multicast function. To do this, check the box. You can then enter the multicast address.

DOC V4.0 2009.06

Installation and Operating Manual

Bosch Security Systems

Page 86
Image 86
Bosch Appliances X40 SN manual Advanced Mode Multicasting, Enable