
20 en Installation | VideoJet X40 SN |
|
|
4.3Connections
Cameras
You can connect four video sources to the VideoJet X40 SN. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable.
1.Connect the cameras or other video sources to the BNC sockets Video In 1 to Video In 4 using a video cable (75 Ohm, BNC plug).
2.If the video signal is not looped through, termination is performed by a software setting if necessary (see Section 5.17 Advanced Mode: Video Input, page 46).
Audio Connections
The VideoJet X40 SN has two audio ports for audio line signals.
The audio signals are transmitted
2 | × Line In: | Impedance 9 kOhm typ., 5.5 |
1 | × Line Out: | Impedance 10 kOhm typ., 3.0 |
|
| impedance 16 Ohm min., 1.7 |
The stereo plugs must be connected as follows:
Contact | Line In function | Line Out function |
|
|
|
Tip | Channel 1 | Channel 1 |
|
|
|
Middle ring | Channel 2 | – |
|
|
|
Lower ring | Ground | Ground |
|
|
|
1.Connect two audio sources with line level to the Audio In socket of the VideoJet X40 SN with a 3.5 mm stereo plug.
2.Connect a unit with
Network
You can connect the VideoJet X40 SN to a 10/100
XConnect the VideoJet X40 SN to the network via the ETH socket.
CF Slot
You can insert a type I or II CompactFlash card into the Compact Flash slot to enable recordings to be saved locally. CF cards are the ideal solution for shorter storage times and temporary recordings, for example alarm recordings or local buffering in the event of network interruptions.
NOTICE!
i You can obtain a list of compatible CF cards from your supplier or directly from Bosch Security Systems. This list is constantly being updated and extended.
Playing back recordings is also possible using a different VideoJet X40, a VideoJet X10 or a VideoJet X20.
DOC V4.0 2009.06 | Installation and Operating Manual | Bosch Security Systems |