80 en Configuration Using a Web BrowserVideoJet X40 SN

5.37

Advanced Mode: COM1

You can configure the serial interface parameters (orange terminal block) to meet your requirements.

NOTICE!

If the VideoJet X40 SN is working in multicast mode (see Section 5.40 Advanced Mode:

i Multicasting, page 86), the first remote location to establish a video connection to the unit is also assigned the transparent data connection. However, after about 15 seconds of inactivity the data connection is automatically terminated and another remote location can exchange transparent data with the unit.

Serial port function

Select a controllable unit from the list. If you wish to use the serial port to transmit transparent data, select Transparent. Select Terminal if you wish to operate the unit from a terminal.

NOTICE!

i After selecting a unit, the remaining parameters in the window are set automatically and should not be changed.

Camera ID

If necessary, enter the ID of the peripheral you wish to control (for example a dome camera or pan/tilt head). The entered ID relates to the peripheral that is connected to the first video input. For further video inputs, the ID is automatically counted up and assigned to the peripheral connected to it.

Baud rate

Select the value for the transmission rate in bps.

Data bits

The number of data bits per character cannot be changed.

Stop bits

Select the number of stop bits per character.

Parity check

Select the type of parity check.

DOC V4.0 2009.06

Installation and Operating Manual

Bosch Security Systems

Page 80
Image 80
Bosch Appliances X40 SN manual Advanced Mode COM1