VideoJet X40 SNConfiguration Using a Web Browser en 35
5.7 | Basic Mode: Audio |
You can set the gain of the audio signals to suit your specific requirements. The current video image is shown in the small window next to the slide controls to help you check the selected audio source and improve assignments. Your changes are effective immediately.
If you connect via Web browser, you must activate the audio transmission on the LIVEPAGE Functions page (see Section 5.15 Advanced Mode: LIVEPAGE Functions, page 43). For other connections, the transmission depends on the audio settings of the respective system.
NOTICE!
i The numbering of the audio inputs follows the labeling on the unit and the assignment to the respective video inputs. The assignment cannot be changed for Web browser connections.
Audio
The audio signals are sent in a separate data stream parallel to the video data, and so increase the network load. The audio data are encoded according to G.711 and require an additional bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be transmitted, select Off.
Line In
You can set the audio signal gain for the line inputs. Make sure that the display does not go beyond the green zone during modulation.
Line Out
You can set the line output gain. Make sure that the display does not go beyond the green zone during modulation.
Bosch Security Systems | Installation and Operating Manual | DOC V4.0 2009.06 |
