58 en Configuration Using a Web BrowserVideoJet X40 SN
| 6. For each profile, click the Set button to save the settings in the unit. | |
| Standard recording | |
| Here you can select the mode for standard recordings. | |
| If you select Continuous, the recording proceeds continuously. If the maximum memory | |
| capacity is reached, older recordings will automatically be overwritten. If you select the Pre- | |
| alarm option, recording will only take place in the | |
| the set | |
| If you select Off, no automatic recording takes place. | |
|
| |
! | CAUTION! | |
You can specify limitations for overwriting older recordings in Continuous mode by | ||
configuring the retention time (see Section 5.24 Advanced Mode: Retention Time, page 59). | ||
|
| |
| Standard profile | |
| From this field, you can select the encoder profile to be used for recording (see | |
| Section 5.19 Advanced Mode: Encoder Profile, page 48). | |
|
| |
i | NOTICE! | |
The recording profile can deviate from the standard setting Active profile for the video input | ||
set and is only used during an active recording. | ||
|
| |
|
| |
| You can select the required | |
|
| |
| You can select the required | |
|
| |
| You can select the encoder profile to be used for recording during the | |
| Section 5.19 Advanced Mode: Encoder Profile, page 48). | |
| The Standard profile option adopts the selection at the top of the page. | |
| Alarm input / Motion alarm / Video loss alarm | |
| Here you can select the alarm sensor that is to trigger a recording. You can also use the | |
| motion and video loss alarm for a camera to trigger the alarm recording by another camera. | |
|
| |
| NOTICE! | |
| The motion alarms are configured and activated for each camera on the VCA page (see | |
i | Section 5.31 Advanced Mode: VCA Event Triggered, page 73). | |
The alarm inputs are configured and activated on the Alarm Inputs page (see | ||
| ||
| Section 5.35 Advanced Mode: Alarm Inputs, page 78). | |
| The numbering of the checkboxes for the alarm inputs corresponds to the labeling of the | |
| alarm inputs on the VideoJet X40 SN. The motion and video loss alarm corresponds to the | |
| labeling on the video inputs. | |
|
| |
| Virtual alarm | |
| Here you can select the virtual alarm sensors that are to trigger a recording, via RCP+ | |
| commands or alarm scripts, for example. | |
|
| |
i | NOTICE! | |
For more information, please see the Alarm Task Script Language document and the RCP+ | ||
documentation. These documents can be found on the product CD supplied. | ||
|
|
DOC V4.0 2009.06 | Installation and Operating Manual | Bosch Security Systems |