Access Ports

The generator is equipped with an enclosure that has several access doors. The doors are named for a significant component located behind them, as follows:

AA - Fuel Inlet port (shown for reference)

B - Control Panel door (may be two doors)

B

CC - Exhaust opening (shown for reference) DD - Coolant Fill door

E - Battery door F - Muffler door

The enclosure also includes muffler and radiator access panels, used for cleaning those components. All panels should remain closed at all other times to assure proper cooling, reduce noise, and for added safety.

NOTE: Doors shown in picture may differ from those on unit.

Each generator is equipped with a set of identical keys. These keys fit the locks that secure the access doors.

NOTICE Before opening and/or removing doors, remove power to the unit by using the following procedures:

1.Press and hold the control board OFF button.

2.Remove 15 Amp fuse from control board.

To open access door:

1.Insert key into lock of access door handle and turn key one quarter turn counterclockwise.

2.Grasp door’s handle and turn one quarter turn counterclockwise to open. Remove key.

3.Coolant Fill door is unlocked in the same manner. It can be used for adding coolant or oil.

 

 

 

To close access door:

 

WARNING Contact with muffler area could cause burns

 

1. Close door and turn door’s handle one quarter

 

 

resulting in serious injury.

 

 

 

turn clockwise.

 

 

 

2. Insert key into lock of door handle and turn key one

• DO NOT touch hot parts and AVOID hot exhaust gases.

• Allow equipment to cool before touching.

quarter turn clockwise. Remove key.

 

 

 

 

Additional force may be required to fully close and lock

 

 

 

the doors because they create a pressurized seal for the

 

 

 

generator enclosure.

NOT

C

D

 

 

for

 

 

REPRODUCTION

A

B

F

E

12