Important Owner’s Considerations
| Engine Oil | Battery |
NOTICE Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure.
•Refer to Maintenance section for coolant and oil fill information.
•Damage to equipment resulting from failure to follow this instruction will void engine and generator warranty.
WARNING Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
The installer must supply a
The engine is shipped from the factory | With the battery installed, all wiring to transfer switch and | ||
with | generator completed, utility power supplied to the automatic | ||
system operation in a wide range of temperature and | transfer switch, and the unit in AUTO mode, the battery | ||
climate conditions. Before starting the engine, check oil | receives a trickle charge while the engine is not running. The | ||
level and ensure that engine is serviced as described in the | trickle charge cannot be used to recharge a battery that is | ||
Maintenance section. |
|
| completely discharged. |
| Coolant System |
|
| 15 Amp Fuse |
This engine is shipped from the factory filled with a 50‑50 mix | The generator’s 15 Amp fuse is critical to correct system | ||
of automotive (Ethylene glycol) | operation. Your installer will ensure the fuse is properly | ||
will provide optimum year round protection against freezing, | installed upon completion of the installation. | ||
boiling and corrosion. The coolant system incorporates an |
| ||
optional water heater that operates with a fixed thermostat |
| ||
set at 100°F - 120°F (39°C - 49°C) AND utility power is present |
| ||
at the transfer switch. Before starting the engine, check |
| ||
coolant level as described in the Maintenance section |
| ||
| NOT |
|
|
| Wireless Monitor | for |
|
|
|
|
| |
The generator is supplied with a |
| ||
monitor. |
| REPRODUCTION | |
|
| ||
The monitor communicates wirelessly with the generator |
| ||
control panel.
Your installer will ensure the wireless monitor is communicating with the generator control panel during the installation process.
14