Brother DCP1200 manual From within Montreal

General Printing Difficulties (Continued)

Scanning Difficulties

Software Difficulties

Difficulty	Suggestions
Vertical Black Lines	Sometimes you may see vertical streaks/black
on Printouts.	lines on printouts. Your machine’s primary
	corona wire for printing may be dirty. Clean
	your primary corona wire (see page 11-17).
	Try printing again. If the problem continues,
	call Brother Customer Service at
	1-800-284-4329 (USA),
	1-800-853-6660 (from within Canada) or
	1-514-685-6464 (from within Montreal).
My headers or footers	Most laser printers have a restricted area that
appear when I view	will not accept print. Usually these are the first
my document on the	two lines and last two lines, which leaves 62
screen but do not show	printable lines. Adjust the top and bottom
up when I print them.	margins in your document to allow for this.
TWAIN Errors appear	Make sure the Brother TWAIN Driver is
while scanning.	selected as the primary source. In PaperPort® ,
	click File Select Source, highlight the Brother
	TWAIN Driver and click Select.
You see the “New	Click on ‘Do not install a driver. (Windows
Hardware Found”	will not prompt you again)’ and click ‘OK’.
message on your PC	(See page 4-12.)
screen (although you
have already installed
the drivers in
Windows 95).
You see the “Update	Follow the instructions from the installer,
Device Driver Wizard”	then click Next. Click Finish when it appears
or “Add New Hardware	on the screen. (See page 4-12.)
Wizard” message on
your PC screen
(although you have
already installed
the drivers in
Windows 95 or 98).
Cannot perform ‘2 in 1’	Check that the paper size setting in the
printing	apprication and in the printer driver are the same.
Cannot print when	Try to reduce the printing resolution.
using Adobe Illustrator.
When using ATM fonts,	If you are using Windows 95/98, select
some characters are	‘Printer Settings’ from the ‘Start’ menu.
missing or some	Open ‘Brother DCP-1200’ properties. Click
characters are printed	‘Spool Setting’ on the ‘Details’ tab.
in the same place.	Select ‘RAW’ from ‘Spool Data Format’.

T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E 11 - 7