Brother DCP1200 manual For Windows -Based PC Using the Bundled Parallel Cable

For Windows® -Based PC Using the Bundled Parallel Cable

IMPORTANT

To install the software using Windows NT® Workstation Version 4.0, you must be logged on as the Administrator. After the Brother Drivers are installed, restart Windows NT® a second time, and log in as usual.

If you are using Windows® 95, after you connect Brother machine to Computer. you may see “New Hardware Found Brother DCP-1200” during startup.

You can select “Do not install a driver (Windows ® will not prompt you again).” and click OK, so Windows® will not display this dialog box again

—OR—

If you see “Update Device Driver Wizard”, click Next to bypass the Windows® Plug and Play Printer Driver screens, followed by Finish.

If you are using Windows® 98, you may see the “Add New Hardware Wizard” during startup, follow the instructions from the installer, then click Next. Click Finish when it appears on the screen.

1Insert the Brother CD-ROM into your CD-ROM drive.

2Enter the command for your version of Windows® , if needed.

After you insert the Brother CD-ROM, you must type the appropriate command for your version of Windows® :

■If you are using Windows® 3.1x, from the Program Manager: Click File, then Run, then type x:SETUP.EXE. (“ x” is the drive letter for your CD-ROM drive.) This will start the Brother Drivers Installation program.

■If you are using Windows® 95/98 or Windows NT® Workstation Version 4.0, the Software Installation program appears automatically when you insert the Brother CD-ROM.

■For Windows® 95/98 and Windows NT® Workstation Version 4.0, you can also click Start at the Desktop, select Run and then enter x:\SETUP.EXE. (“ x” is the drive letter for your CD-ROM drive.)

The Brother LOGO will be displayed on the screen.

4 - 12 C O N N E C T I N G T O A P C