Ring Security Configuration
NOTES |
The spmarun script invoked first in the above command temporarily sets the environment variables SPMA needs to operate; be sure to use this command any time you launch an application from the command line. This script is automatically invoked when you launch an application from the icon menu or from within the Hub View.
If you wish to change any Security settings, be sure to use a community name with at least Read/Write access. If you only wish to view current settings, a community name with Read access will be sufficient.
If there is a hostname mapped to your TRMMIM’s IP address, you can use <hostname> in place of <IP address> to launch this application. Please note, however, that the hostname is not the same as the device name which can be assigned via Local Management and/or SPMA; you cannot use the device name in place of the IP address.
The Security Configuration Ring Selection window, Figure 6-1, will appear.
Figure 6-1. The Security Configuration Ring Selection Window
The Ring Selection window displays each manageable network supported by the monitored device, and lets you access a Security Config window to configure security for the selected ring. Networks are identified by the following two fields:
No.
The index number assigned to each ring network.
Ring Name
This field displays the ring name assigned to each network.
To set up security for the ring network being managed by the TRMMIM, click mouse button 1 to select the desired ring, then click mouse button 1 on 
. The Security Config window (Figure
Launching the Security Configuration Window |
