Cannot print over a network

Cannot connect the printer to the network

Cause		Corrective Action
The Ethernet cable is not connected	1.Make sure the printer is connected to the network with the correct
correctly to the printer’s Ethernet port.	Ethernet cable, and then turn the printer on. For instructions on

	connecting the cable, refer to the Quick Start Guide.
	2.Make sure the Link indicator is lit.
	The Link indicator is green if the printer is connected via 100
	Base-TX and orange if connected via 10Base-T.
	If the Link indicator is not lit, check the following points.
	•	Make sure the hub is on.
	•	Make sure the end of the Ethernet cable is connected
		correctly.
		Insert the Ethernet cable until it clicks and locks in place.
	•	Make sure there is no problem with the Ethernet cable.
		If there is any problem, replace the Ethernet cable.
	•	Check the communication mode with the hub.
		Although the printer normally detects the hub
		communication mode and transmission rate automatically
		(in auto negotiation mode), sometimes the hub settings
		cannot be detected. In this case, congure the connection
		method manually, specifying the communication mode in
		use. (→P.677)

676 Troubleshooting