Canon 3175B002 user manual Paper Details, Setting Item Description, Instructions

			Control Panel
Paper Details
	Setting Item		Description, Instructions
	(The paper type is	Roll DryingTime	Specify the time to wait for the ink to dry for each sheet.
	displayed here.)(*1)
		Scan Wait Time	Specify the time to wait for the ink to dry between each scan
			in bidirectional printing, in consideration of how quickly the ink
			dries. Note that printing will take longer if you specify a wait
			time.
		Feed Priority	Specify exact paper feeding, if desired. Normally, select
			Automatic. Choose Print Length if you prefer to feed the
			paper an exact amount. However, note that choosing Print
			Length may result in slight banding in the direction of Carriage
			scanning.
		Adjust Length	Displayed if Feed Priority is Print Length.
			Adjustment relative to the amount of stretching or shrinkage of
			the current paper.
			Enter either the adjustment results from Print Pattern or the
			discrepancy that you measured (as a percentage).
			For paper that tends to stretch, increase the feed amount by
			choosing a higher adjustment value. For paper that tends
			to shrink, decrease the feed amount by choosing a lower
			adjustment value.
		Head Height	Adjust the Printhead height. (→P.576)
		Skew Check Lv.	If you print on Japanese paper (washi) or other handmade
			paper that has an irregular width, choose Loose for a higher
			skew detection threshold, or choose Off to disable skew
			detection. However, if paper is loaded askew when detection is
			Off, note that paper jams or Platen soiling may occur.
		VacuumStrngth	Specify the level of suction that holds paper against the Platen.
			(→P.587)
		NearEnd RollMrgn	Specify the minimum margin at the leading edge of roll paper to
			ensure better printing quality at the leading edge.
			Note that if you choose 3mm, it may lower the printing quality
			at the leading edge and affect feeding accuracy. The printed
			surface may be scratched, and ink may adhere to the leading
			edge. It may also cause the Platen to become soiled.
		Cut Speed	Choose the cutting speed. If you use adhesive paper, choosing
			Slow helps prevent adhesive from sticking to the cutter and
			keeps the cutter sharp.
		Trim Edge First	If a roll is loaded, the end of the paper will be cut.
			Choose On to have 40 mm (1.6 in) cut off the leading edge of
			the roll after you load the roll. Scraps are then removed.
			When Automatic is selected, if the left and right side of the
			leading edge of the roll are uneven (by 3 mm [0.12 in] or more),
			the edge is cut an amount relative to the slant to ensure a
			straight edge after you load the roll. Scraps are then removed.
			If the unevenness is less than 3 mm or if Off is selected, the
			edge is not cut and scraps are not removed.

Printer Parts 61