Canon iP3300 manual Loading Paper

edge of the stack.

When loading paper in the Front Feeder, load the paper with the print side facing DOWN. Align the right edge of the paper stack against the right edge of the Front Feeder and slide the Paper Guide against the left edge of the stack.

When loading paper in the Front

	Feeder, make sure that the paper is
	not set over the protrusion above the
	Load Limit Mark on the Paper Guide.
	For details on loading paper, see
	Loading Paper.
Paper source	You cannot load paper other than
selection is	A4, Letter, or B5-sized plain paper in
inappropriate.	the Front Feeder. When using any
	other type of paper, load it in the Auto
	Sheet Feeder.
	In the printer driver, select the
	paper source where you loaded the
	paper for Paper Source. For details,
	see Basic Printing.
Too much plain	You can load approximately up to 150
paper loaded.	sheets of 17 lb / 64 gsm plain paper in
	the Auto Sheet Feeder (0.52 inches / 13
	mm in stack height), and up to 110
	sheets of 17 lb / 64 gsm plain paper in
	the Front Feeder (0.39 inches / 10 mm
	in stack height). However, proper
	feeding of paper may not be possible at
	this maximum capacity depending on
	the type of paper or environmental
	conditions (either very high or low
	temperature and humidity).
	In such cases, reduce the sheets of
	paper you load at a time to around half
	(around 0.2 inches / 5 mm in paper
	stack height).
	For details on loading paper, see
	Loading Paper.

157