Canon MP470 quick start Error Message Appears on a PictBridge Compliant, Device

•Error No.: 2002 Is Displayed

PictBridge compliant device isSee "An unsupported USB hub is connected. Remove the hub." in "An Error

connected via an unsupported USB Message Is Displayed on the LCD" on page 57.

hub.

Error Message Appears on a PictBridge Compliant

Device

i

The following are the possible errors that may occur when printing directly from a PictBridge compliant device and the countermeasures to clear them.

Note

•This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The error messages and operations may vary depending on the device you are using.

For errors on non-Canon PictBridge compliant devices, check the error message on the LCD and take the appropriate action to clear the error. For details, see "An Error Message Is Displayed on the LCD" on page 57.

•For the errors indicated on the PictBridge compliant instruction manual of the device. For other troubles

device and their solution, also refer to the on the device, contact the manufacturer.

"Printer in use"

"No paper"

"Paper jam"

If the machine is printing from the computer or warming up, wait until the job ends. When it is ready, the machine starts printing automatically.

When printing first after changing the media type, the message asking you to confirm the position of the Paper Thickness Lever may appear on the LCD on the machine. If this message is displayed, make sure that the Paper Thickness Lever is set appropriate, then press the OK button on the machine.

Load paper in the Rear Tray, and select Continue* in the display on your PictBridge compliant device.

*To resume printing, you can also press the OK button on the machine instead of selecting Continue on the camera.

Select Stop in the display on your PictBridge compliant device to stop printing.

Remove the jammed paper, load new paper, press the OK button on the machine, and try printing again.

"Printer cover open"	Close the Scanning	Unit (Printer Cover) on the machine.
"No print head"	The FINE Cartridge	is not installed or the Cartridge may not be compatible with
	this machine.
	For details on how to resolve the error, see "The following ink cartridge cannot
	be recognized. UO511UO521UO531U059"in "An Error Message Is Displayed on
	the LCD" on page 57.
"Waste tank full"/	The ink absorber is nearly full.
"Ink absorber full"	For details on how	to resolve the error, see "The ink absorber is almost full.
	Press [OK] to continue printing. Contact the service center." in "An Error
	Message Is Displayed on the LCD" on page 57.

70Troubleshooting