7
Chapter 7 Print Control Codes
(58)Cutting of paper (GS V m, GS V m n)
Code: (1) [1D] h + [56] h + m
(2)[1D] h + [56] h + m + n
*(1) (0 ≤ m ≤ 1)
(30 ≤ m ≤ 31) Data are expressed in Hex code.
(2) (41 ≤ m ≤ 42)
(0 ≤ n ≤ FF) Data are expressed in Hex code. This command executes the specified paper cut.
m | Function | |
|
| |
0,30 | Full Cut | |
|
| |
1,31 | Partial Cut (1 point left) | |
|
| |
41 | (Cutting position + [n x basic calculation pitch] ) | |
paper feed and full cut. | ||
| ||
|
| |
42 | (Cutting position + [n x basic calculation pitch] ) | |
paper feed and partial cut (1 point left). | ||
| ||
|
|
•In the Standard mode, this command is valid only if it is input at the head of the line.
In the case of (1):
•When m = 1 or m = 31, a partial cut (1 point left) is executed. In the case of (2):
•When n = 0, after executing paper feed to the cutting position, the paper is cut.
•When n ( 0, after executing paper feed [n x basic calculation pitch] inch from the cutting position, the paper is cut.
•The basic calculation pitch is set by GS P.
•The paper feed amount is calculated by the vertical basic calculation pitch (y). Also, if there is a fraction, interpolation is carried out at the mechanism's mini- mum pitch. Remainders are cut off.
92
