Cautions for Installation
•Do not use or store this product in a place where there is fire or water vapor, where it will be exposed to direct sunlight, in a place where it will be exposed to heat or humidity conditions that it was not specified for, such as next to a heater or burner, or a place where there is a lot of oil, iron filings, dust or dirt, etc. Doing so could cause it to break down, emit smoke or catch fire.
•Do not install this product in a place such as an experimental laboratory where there are chemical reactions taking place, or where there is salt or gas in the air. This could cause fire or electric shock.
•Install on a level, stable table which doesn't vibrate, in a location where there is good ventilation. (Do not cover the air holes.)
•Do not place any articles on top of the printer. It could cause it to break down.
•Do not use this printer near, or plug it into the same outlet with, a radio or television receiver. Doing so could interfere with reception.
•Do not use this product at a voltage and frequency other than the specified voltage and frequency.
•Make sure the circuit where this printer is plugged in has sufficient surplus capacity to operate this printer without trouble.
•Avoid attaching this printer's power cord to an overloaded electric circuit. If the circuit is overloaded, it could cause the electric line to overheat and cause a fire, or trip the circuit breaker. Also, do not walk on the power cable or place objects on top of it.
•When disconnecting cables, always switch off the power first, then take hold of the plug or connector and disconnect them. Do not pull on this product while a heavy weight is bearing on the cables or attempt to carry it by holding the cables.
•Connect the cable connectors securely. Particularly, if the cables are connected with the polarity reversed, it could destroy the internal components, and also have a bad effect on the device on the other end of the cable.
•In order to avoid garbling of data, etc. due to noise, always use shielded signal lines or twisted pair lines. Also, please avoid connecting this printer with a device that generates a lot of noise.
•Use this printer in a place where it is near to an outlet, and the power plug can be pulled out easily, and under conditions where the power supply can be cut off easily.
