Chapter 9 Service/Subscriber Provisioning
Service Provisioning
Configuring and Commissioning a Service Instance
After you create the service instance object, you should configure and then commission the service instance from the appropriate Service Configuration window. The service instance object can be configured in two ways:
•By applying an appropriate service profile and then manually configuring each of the remaining parameter in that service instance.
•By manually configuring each parameter in the service instance.
This section describes how launch the appropriate Service Configuration window, apply a service profile (if required), configure the remaining parameters, and then commission the service instance for each of the available Cisco 6400 SCM services. Figure
Figure 9-52 Configuring and Commissioning a Service Instance
Launch the
appropriate Service
Configuration Window
For example, launch the ATM Service Configuration window to configure a Pure ATM service.
Apply an existing
Service Profile to a
Service Instance
Apply an existing profile (if required).
It is not possible to create and apply a profile to
a Pure ATM service.
Configure an
Appropriate
Service Instance
Configure the remaining parameters manually or configure all of the parameters manually (if you did not apply a service profile).
Click the |
| |
Commission Service | 41808 | |
button | ||
| ||
|
|
Click the Commission Service button to save the configuration and "roll" the service onto the 6400 UAC hardware.
Cisco 6400 Service Connection Manager User Guide
| ||
|
